Horns on hairband

The horns have a tight fit on the hairband so that you can adjust the position as you like, no glue needed.

Horns printed in PLA (matt PLA was used for the pictures)

• both 0.1 or 0.2 mm layer height should work.
• 15% infill is sufficient for having good stability at the base 
  (you can add a modifier with 0% infill at 60mm height)
• for best quality print horn separately  

Hairband PLA or PETG

• both 0.1 or 0.2 mm layer height should work.
• no infill needed
• organic support for the connectors

Hairband adjustments:

• too narrow … try to gently bend it in your hands
• too long … cut the ends with a cutter knife or side cutter and sand the sharp corners

Adaption to be printed with hairband