muzi.works H1 Charging Cradle

This is a charging cradle for the muzi.works H1 for the Heltec V3. It allows the device to stand upright while charging or while it is hooked up to a computer. It uses these (amazon) right angle USB C connectors which fit inside the bottom. The base is secured with 4 M3-8 Or 4 M3-10 Screws.. You will also need 4 M3 Heat Inserts from CNC Kitchen here (CNC Kitchen). Other threaded inserts may also work.

The modeled in supports are designed around a .2mm layer height. The models must also be reorientated before printing. They will print best with the flat bottom facing down.

I recommend printing these with at least 3-4 walls as the heat inserts will have a lot of pressure pulling on them as you tighten on the base and i have found they stay in better with more than 2 walls. I also recommend printing at a higher infill for weight and stability.

This is a charging cradle for the muzi.works H1 Case. It was modeled around the case to be a secure fit.