Wire Shelf and DIN Rail Mount

Remixed to fit a different DIN rail that I have, which has a more shallow depth (just under 8 mm) and a protrusion from either side of the base, instead of a flat base.

This profile is more commonly found on extruded DIN rail, as opposed to roll-formed, bent, or pressed DIN rail, but is compatible with both!

Printed in OrcaSlicer at 0.28 mm with tree supports against the bed only.
If you print with support everywhere, the toruses for the zip-ties are going to be over-supported and difficult to remove.

Remixed to fit the DIN rail extrusion I have that has a more shallow depth (just under 8 mm)