FPV Drone Propeller protective case

A simple case to protect your propellers (this is for a 5 inch drone). It fits a 3 blade propeller (120 degrees angle between each of them)

The case has a lid that can be clipped on top (sand a little bit the corners for a nice fit)
You can go fancy and add a hinge or drill a hole at the top to add something to lift the lid…I personally don't need it…but you might (everyone is different)

I can fit 6 or 7 props per case, you can make it taller of course depending on what you need.

• Made out of PLA (cheapest and simplest to print)
• 210 degrees
• No support
• Took 45 min for both prints