DJI Neo - DJI Avata 2 hard case conversion

I wanted a hard carry case for the DJI Neo that held the drone, motion 3 controller, rc-n3 controller, goggles 3 and the charging hub but could not find one that did all of this.  In the past I've had similar opportunities to convert an old carry case into some other carry case so I put past experience into this by modding a new case right from the start.  This design has 3 insert to convert a DJI Avata 2 case into a DJI Neo case.

I found the Avata 2 case at Amazon:

https://www.amazon.com/dp/B0CYH3CX7H?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

I printed the Avata 2 drone insert in Polymaker ASA but you could use any material at 10% rectangular infill, 2 parameters (on my Bambu Labs X1C).

The Neo drone and the charging hub inserts I printed using SainSmart TPU 95A at 10% rectangle infill, 2 parameters (on my MK3S+).