Remix of RyanDam's Cable Management Duct for Voron 2.4 300mm printers.

These  files were based on MyStopidStuff's Remix of RyanDam's Cable Management Duct for Voron Printers Version 2.0 in order to customize his parts to work within the confines of a Voron 2.4 300mm build. 
All my customized pieces are based on the updated and improved v2.0 of his duct system (With minor modifications for fit and looks). I've made them easy to line up for a neat looking layout (if you like how I laid mine out with a middle channel for additional routing options).
The corners where scaled down in Z to 80% to fit under the motors (tight spaces) and still allow you to easily apply the lids.
The tools are just quick jigs I made and aren't necessary (1.9mm thick). I used them by pushing them to the side extrusions then the parts against them then down for a perfect line that gave you room to easily add and remove the lids when finished. The parts have “toes” on them to just push end to end for perfect lineup and maintained distances.
The cutout bridge is to allow you to use the PSU brace while maintaining a clean and coherent look.
I posted a pic with my layout after how the pieces are named for a quick and easy build.
The ducts are printed in PETG (ASA didn't work out prior to MyHotSTuff's redesign being to brittle) and the lids in ASA. I highly recommend printing the ducts in PETG (and I used the standard Voron settings).

For the Pi mount I'm using that works well with this cable management try MyStopidStuff's remix https://www.printables.com/model/1028792-low-profile-din-offset-mount-for-raspberry-pi-3b-4 

Customized pieces to fit a Voron 2.4r2 300 build.