In this design, which I made by improving the previous design a little bit, I improved the size and the top cover slot. I also made it portable with a table stand and additional pieces that you can stick on the wall. I am also adding a few designs that you can put on the top.
2 different top caps, one long and one short.
The Deadpool remix was made from https://www.printables.com/model/884197-deadpool.
For this project I used IC-125B switch, IC-258 Dc jack and Everylite 3-Lens Module Led. You can use it with a 12 volt adapter or with a powerbank using a 5v-12v converter usb.
In Mainpart I only used support above the printing plate. In Deskpart2 support is required.
The author marked this model as their own original creation.