K1 max riser (tall) + BTT Smart Filament Sensor v2

I did a remix of two great designs to create a taller riser because my ptfe was rubbing on the glass after installing the cyclops extruder.

You can print 4 corners without the holes if you are using the stock filament sensor.

The text is written directly in the slicer through the “Emboss” tool. 

For the printed model I used “fuzzy skin” (0,2mm distance+thickness) to cover VFA.

Wirring:

1. runout sensor on original sensor plug
2. motion sensor on pa10 pin on the toolhead

Changes in printer cfg:

[filament_switch_sensor filament_sensor]
pause_on_runout: True
switch_pin: PC15
runout_gcode:
  {% if printer.extruder.can_extrude|lower == 'true' %}
    G91
    G0 E30 F600
    G90
  {% endif %}

[filament_motion_sensor encoder_sensor]
switch_pin: nozzle_mcu:PA10
detection_length: 20
extruder: extruder
pause_on_runout: True
runout_gcode:
  {% if printer.extruder.can_extrude|lower == 'true' %}
    G91
    G0 E30 F600
    G90
  {% endif %}
event_delay: 5.0

Taller by 6cm.