Yeti Mug Holder for Car Cup Holder

My mom loves her yeti mug, but it didn't fit in her car's cupholders, so I designed this. It works as intended, and she loves it. It should also work with any other mug that is about 100mm in diameter and short enough to not tip over in it. The slot for the handle is 25mm wide.

The part that goes into the cupholder is 80mm diameter at the bottom, 90mm at the top, and 60mm tall. This fits the cupholders in several of my vehicles very well. If you need different dimensions, I can add another version of the model with different dimensions, but you'll need to tell me what they are.

I'll try to get some pictures on here later.

If people are interested I could also throw together a version that doesn't need supports but has to be glued together. I'd have to add a centering guide but it wouldn't be too much work.

NOTE: If your car sits out in the sun and it gets warm where you live, PLA will get soft, so you'll want to use PETG or ABS (or anything else heat resistant.) 

It takes around 160g of filament.