Scratch Attach - Printed, Telescopic Back Scratcher v1.0

This short (90 sec.) video shows all you need to know:

The Best Back Scratcher You've Never Had To Buy! 

Printed on my fast CoreXY printer (Flashforge Adventurer 5M) in 1.5 hours. 

Expands from 212 mm to 550 mm! That's 8 3/8" to 21 5/8" in Freedom Units!

• Printed in PLA.
• Print as oriented.
• No supports needed.
• Scratcher part should be a press fit. If loose, add a dab of CA glue.
• Secure the base cap on the bottom using some CA glue.

Also, a new Scratch Attach “tip” has been made (as a remix), so now there are choices for the scratch attach “business end“! See link below, and thanks to @Boomerguy_775659 for the remix!

https://www.printables.com/model/1029675-classic-scratcher-tip-for-scratch-attach

Check out my many other models, and check out my designer club! https://www.printables.com/@design8studio/models 

My PayPal tip jar: https://paypal.me/design8studio 

Tagged: Scratch Attack