Right hand back Scratcher

Model of a right hand with curved fingers with which you can scratch yourself or others.

The model has no hole at the bottom, so you can use the PrucaSlicer to add a hole of the desired size with a negative volume. In the example in the picture I have added a cylinder of 10.4mm so that I can insert a 10mm rod.

I have improved the model itself, so the printed model on the photo is slightly different from the model file. I printed the hand horizontally with quite a lot of support, which led to a lot of post-processing. However, I am satisfied with the result.

The fingers are bent further into a scratching gesture. In addition, the hole at the rear end has been removed so that you can insert a hole of the desired size yourself if required, e.g. with the Prusa Slicer.

The model in the photos is the horizontally printed version.