halloween pumkin tealight

I made this Halloween decoration to make a reflection with a pumpkin face, made in 3 parts, very easy to print and in a short time, it glues one base to the other, leaving the base where the tealight (4mm) goes to the top, then just fit the pumpkin! My tealight gives low light but if you use a white light the reflection is greater! I hope you like it!

-3mf file is ready to print 

-the stl file : layer 0.2 /15% infill

                      wall generator arachne

                      top surface pattern hilbert curve (optional)

                      no brim