DJI RC2 Mount

Designed to work with the DJI RC2 controller and the FPVtosky RC 2 Sun Hood Shade installed, this design will let you secure the controller to a gopro mount, typically for handlebars on a bike or, I guess, wherever you want!

WARNING: Use the STEP files; DO NOT use the stl, it's only for site preview purposes.

Main Body: The STEP file has supports built in, they snap away after printing. Do not print with generated supports. DRY YOUR FILAMENT and slow down the print – this is all overhangs, all day and will print very poorly if you aren't dialed in.

GoPro Mount: Split the file into bodies and print the “ears” face down. This will print them in the best orientation for strength. Then just slide them through the base piece before bolting it onto the main body.

Knobs: Use the knobs from the remix parents; they work fine.

Print Settings/Material: I used PETG-CF for my print, PETG would likely work fine as well. 

---

This can be used without the sunshade attachment, but it's about 1.5mm short. You can go into the Fusion file and undo some of the last few steps where I chop down the “neck” to return the body to a length where this will work with no shade attached.

Quite a few:

• Prints at a 45 degree angle for best layer line resistance
• Designed in supports
• Changes the vent holes to be slots for better printing
• added many filets and thickened parts for a sturdier print
• remodeled gopro mount to be a 3 part print