Kukirin Fender

The Kukirin G2 is a well-built electric scooter, but for some reason, it only comes with a low-quality rear fender. To protect the shock absorber and myself from water, I made two fenders: one for the front, secured with two screws, and one for the back, attached using two cable ties.

The front fender is made up of three parts: the main fender, the lower extension (which I didn’t use because it didn’t seem very important in the end), and a piece that allows for mounting the nuts. To install it, you'll need to remove the front wheel, position the fender with the support behind it, and screw in the bolts with the nuts on the shock absorber side.

The rear fender should be printed flat, and with the help of a heat gun, you can bend it as you prefer.

In the end, I had some scrap plexiglass, so I used that instead. The result should be the same.