Banana Knife QOL Remix

Here is my QOL update for the banana knife. I added additional magnets to make the closed banana more stabile and together. Makes the closing mechanism easier to use as well. Also changed the magnet size to 5mm as I felt the original 10mm magnets were far too big. In the photo'd banana above I couldn't get my 5mm magnets to squeeze in so I super glued 4mm magnets in, not sure if it was my magnets or printer that caused them not to fit. ALSO sorry its sideways but I'd highly recommend rotating the blade upright to print.

TIP: glue the bottom banana piece to the connecting block and push it all the way in first. Then attach to the banana blade housing. If you glue the connecting block to the banana blade housing first it could push the blade to far up not allowing it to close properly.

Thanks to the original creator: https://www.thingiverse.com/thing:6638606

Added additional magnets to make the closed sword more stabilized, as well made the mangets smaller as I felt they were too large for the small size of the knife.