VAXEE NP-01S 4K Lightweight Base

This base replaces the original one found on the NP-01S 4K in order to save up to 9g.

Please keep in mind that the buttons on the bottom of the PCB are hard to reach after installation.

Feel after installation is close to stock, but expect a tiny bit more lateral flex towards the centre of the mouse.

Weight on picture is with an 80mAh battery (I HARD recommend not going lower than 120mAh on the NP-01S 4K).

If your lens isn't stuck to the sensor, you can glue the prongs that stick through onto the top of the sensor from above with some superglue or a glue gun.

THIS BASE IS ONLY COMPATIBLE WITH THE NP-01 4K MODEL.

Made by Jakeu

jakeu.gg