Kitchensink organizer

I printed the body in PETG and put some epoxy at the bottom on the inside to seal it. The grid is printed in ASA, but really anything else should be fine too, I just wanted to make sure I can put it in the dishwasher on occasion.

The step at the bottom is 4.5mm high.

The bigger version is 65mm high, 106mm deep and 246mm wide. 

The smaller version is 65mm high, 106mm deep and 156mm wide.

I use the bigger one for sponges and scrubbers and the smaller one for dishsoap and handsoap, but both fot enough to be standalone.

I got inspired and made a version with a little higher walls and a step at the bottom so that it would better fit my kitchensink, it should work fine for anyone else though.