IRONFIST Cordless Vacuum (Milwaukee M18 knock-off) Mount/Holder

Details:
Bracket designed for IRONFIST Cordless Vacuum (Milwaukee knock-off), compatible with a variety of Milwaukee M18 18V battery models. Mount anywhere… wall, workbench, french cleat.

Included are two .STL files, one for M18 2Ah battery, one for M18 5Ah battery. Mount using #6 (or #8) wood screws, whatever length suits your personal requirements. If you prefer to use #8 screws they're a bit tight but should work.

Notes:
Refer to image (green) for correct print orientation.  I used paint-on supports inside mount holes. No other supports are needed. This mount DOES require a battery be installed in the vacuum at all times.

*Printed on AnkerMake M5C (0.4 mm nozzle - 220x220 mm bed).

Hardware:

#6 x 1" (length as needed) Wood Screws - 3 total.

Suggested Print Settings:

Perimeters:  2

Layer Height:  0.16

Fill Density:  15%

Fill Pattern:  Rectilinear

Filament:  PLA+ (37.81 g)

Brim:  No

Supports:  Minimal (see note above).