Air duct for 120mm fan on Iceriver KS0, KS0 Pro, KS0 Ultra, AL0 and RX0

This air duct for the Iceriver KS0, KS0 Pro, KS0 Ultra, AL0 and RX0 Miners is designed for mounting an external 120mm fan to lower operating temperatures in devices that are significantly overclocked.

To install, just push the air duct over case of your Iceriver miner. make sure the heatsinks are parallel to the intended airflow. This way either your ethernet or the power cable will be inside the air duct. The cable can easily be located between the heatsinks. Therefore there is no hole in the air duct.

It is reccommended to replace the side panels with a grille or remove them completely to improve the airflow:

https://www.printables.com/model/698425-mesh-covers-for-iceriver-ks0-pro-ks0-ultra-al0-and

Optionally, a single air duct can be mounted on one side to blow fresh, cool air into the case, while the panel on the opposite side should be removed or replaced with a grille. Alternatively, two air ducts can be mounted for air intake and exhaust. Depending on the choice of external fan, it can either be connected via the miner's USB port or, for high-airflow fans (usually 12V), through an external power supply.

Printed with:

• eSUN ABS+ Black
• @270°C
• 0.3mm layer hight
• 0.6mm nozzle
• on Bambu Lab P1P (+ enclosure)