Fabritec Base Cabinet Drawer Front Clips

This is the "drawer front clip" for the Fabritec base cabinet. I found a few models online, but it's too thick and the “anchor" sections are missing. So I ended up drawing my own.

Here's the Fabritec's installation manual - http://www.cuisine-eurostyle.com/wp-content/uploads/2014/04/PLAN-0317.pdf

Slicer Settings:

• Layer: 0.2mm
• Infill: 10%
• Support Structure: Normal
• Support Density: 15%

I printed it anchor side down with support. Adhesion is going to be a problem, I used a glue stick on a PEI flex plate.