Espresso Filter-Basket Tray for Skadis

Espresso 58mm Filter-Basket Tray for Skadis, but can also be mounted using screws.
There are two versions, one that holds six filter baskets and one for only one filter basket.

Best you first print the “one filter” variant and tune you printer, then print the big one, it will take a while. 
I printed them in PLA (3 walls, 3 top 3 bottom) Infill (10%)

Use these TNuts to mount them on Ikea Skadis walls. I glued the guide to the hanger. I used the M2 variant, but the M2.5 should also work, you may need to open up the holes a bit more. you need to print n guides and n tnuts, where n is the number of holes your trays will have. 

E.G: 

• For the “one” filter variant you need 2 guides, 2 TNuts and 2 M2x12 screws + 2 M2 Nuts
• For the “six” filter variant you need 4 guides, 4 TNuts and 4 M2x12 screws + 4 M2 Nuts

I have 2 of the ones that hold 6 filters to store all my filter baskets, I also use one of my deeper baskets to hold my WDT tool on the top of the tray. This is possible because the the top filter sits flat. They also can be stacked horizontal without a significant gap. I am not sure about vertical stacking. 

Tip: I use the “one” filter version to hold IKEA GRILLTIDER dip sauce bowls, those are great to dose beans but also to clean the 58MM espresso machine, Use two of the dip bowls to act as “double walled" and just press them against your machines gasket while flushing, this way you can avoid the usual mess that happens while flushing. 

Note: Filters that are too high can make it harder to remove the ones below the high filter, especially if the filter below is also high. It works pretty good for my use as i tend to not swap filters too often so its more for storage. And you can still get it out just a bit more tedious. TLDR if you have lots of high filters, you may wanna edit the CAD to your needs. My highest filter is around 30mm