Anycubic Kobra 2 Neo - Small Diameter Top Mount Spool Holder

Small Diameter Top Mount Spool Holder for an Anycubic Kobra 2 Neo

A lot of my filament has a smaller diameter of around 32mm and won't fit on the standard filament holder or any I could find.

A day off, a few hours with some calipers and some tinkercad and here it is.
It's holding an almost full spool without deforming and working well thus far.

Mounted with some M4 screws and washers I had in a pack of metric screws I had ordered years ago.
The washers may not be necessary but seemed like a good idea…

If I experience any issues I will update the model and make notes here.

PrusaSlicer
Printed on my Anycubic Kobra 2 Neo with
  20% infill
  Gyroid fill pattern
  2mm brim