Cartographer Probe Right Angle 90 Degree Assembly Jig

This is a simple Jig for assembling the Cartographer probe in a 90 degree configuration.

Insert the JST Socket with the pins facing up, solder it to the MCU board, then flip the whole assembily over and solder the 90 degree pins to the coil board.

The coil board can be held in place with 2x M3x6 Screws (the ones from the carto packaging work)

Printed & Tested in PLA with a ,2 Layer Height, no fancy support/infil needed, 10% triangle is fine & 3 walls/top/bottom layers.