I feel like I have a different tag than the maker? My Moto Tag doesn't fit. It's too thick and the roundel part doesn't fit the cutout. Either direction.
Moto tag holder
The Moto tag is the same size as an A**le tag, but it has a button. This holder allows you to use the button.
5
90
0
801
updated
September 26, 2024
Makes
Comments
@Max_Plastix_219220 Hmmm, not sure I know what to say. It does take a very small amount of pressure to bring the two halves together. This holds the Moto Tag firmly. The cutout and speaker match. If you are having trouble, you could try scaling. I will say that if you try fitting the Moto Tag with the plastic battery tab in place, it definitely will not fit--I tried that. I'm sorry you are having difficulty. If you keep having trouble, perhaps you could post a picture?
@Max_Plastix_219220
Concerned about @Max_Plastix's comments, I tried several different prints yesterday, scaling up by a few percent in the X-Y plane. The result was that the Moto Tag was now held loosely rather than snugly. However, I am confident that I have the correct dimensions. Again, sorry you are having difficulty.