PicoNES for RP2040-PiZero

Case designed for the PicoNES software along with the Waveshare RP2040-PiZero. PicoNES software and plenty of great information can be found here: https://github.com/fhoedemakers/pico-infonesPlus note theres also a SMS emulator (and GB but that currently requires a Pico2 so not compatible with this device)

You'll need: 

-Waveshare RP2040-PiZero 

-2x NES controller ports (7pin 90 degrees) cheap on Aliexpress 

-Wires/cables to connect board and NES ports together. 

-4x 6mm M3 bolts

There isnt a massive amount of space for the wires because it started to get pretty out of proportion so you wont be able to fit any breadboard style connectors between them, you might be able to cut the NES ports possibly but I havent tested this. I used DuPont (just the bare connectors, no plastic) for the main board and soldered the wires onto the NES ports.

Print Settings

Printer Brand:

Bambulabs

Printer: 

Bambu P1S

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

15%

Notes:

PLA will be fine, make sure your bottom layer is good for the top shell!