Orbiter2.0 Filament Cutter for ERCFV2 with two sensors

Orbiter2.0 SB model adapted for ERCF toolhead sensor, entry sensor & cutter

There are only toolhead sensor version and toolhead&entry sensors version, of which the dual sensor version is 1mm higher and refers to the double step design of CW2 modification to prevent filament jamming.

The balls of both sensors are 5.5mm in diameter, and the top quick connector is ECAS04 (the spring pad under ECAS04 needs to be removed for installation).

Both versions are adapted for side wiring board installation and back ebb36 type CAN board installation (CAN board has front and side PG7 brackets).

Both are adapted for drag chain and pigtail solutions.

A short section of tube needs to be installed under the extruder.

This model is integrated from multiple open source models, and will not be listed one by one. Except for the main parts, the others are directly transported, and friends can print according to personal circumstances

The dual sensor version is recommended.
Because the feed line at the top of orbiter2.0 is too short in the original design, it is very easy to get stuck.  

Beta version! ! ! ! ! ! ! ! 

 support Filament Cutter for ERCFV2 with two sensors