Sliding RackRoller: Add-On Part to the RackRoller by @Repkord

If you're like me, I move my spools along my RepRack all the time so I never set the set-screws on my RackRollers… But as a result, my RackRollers tend to fall off my RepRack 😠 So I made these clips/locks, of-sort, to keep the RackRoller attached to the RepRack while still allowing you to slide them side-to-side! 

That's a lot of RRRRRRs… 😁

I printed mine in Prusament Clear PETG but PLA should work just as well.

Nozzle: 0.4mm

Layer Height: 0.2mm - Lower for finer layer lines

Perimeters/Walls: 2 - Add more for more strength

Infill: 100% - But not necessary; lower is desired

I hope you find this print useful and please post your makes!

Add-on part to the original RackRoller.