Custom Fingertip Mouse V4

A sub 20g fingertip mouse for the vgn f1 internals.
7
54
0
578
updated September 23, 2024

Description

PDF

THIS IS NOT FINISHED

Measurements may not yet be perfect, it is a work in progress. I ordered the print in 9600 resin from jlcpcb, and the part has to flex a LOT currently to get the pcb into position. I doubt it would work with sls or mjf so if you print with it (or any other less flexible material) it will likely snap. I plan to change this in the future as I would prefer to print it in nylon sls. The resin print came warped so I had to fix it in hot water. In short, dont expect a working mouse from this print, it needs work.

 

To build it, you will need to solder a new 5mm encoder and a 3.5mm tact switch for middle mouse button. I ordered the kailh red encoder and some huano mute 6*6*3.5 switches. The smaller printed scroll wheel is required for it to fit. I also used a 150mah battery to get the weight under 20g. The pcb screws in with the stock screws so no more needed. For skates, I use 4 x-raypad Jade dots.

Tags



Model origin

The author marked this model as their own original creation.

License


Highlighted models from creator

View more