Parking Assist

This is a simple, but effective adjustable parking assist. It is easy to assemble and install.
This is an exclusive model available only to supporters of the creator.
Your funds support the creator's further activity.
$5 /month
0
0
12
updated October 6, 2024

Description

This is a simple, but effective adjustable parking assist. It is easy to assemble and install. It is mostly 3d printed, but dose requires some extra hardware.

Parts

  • Ceiling bracket (included)
  • Ball (included)
  • Stopper (included)
  • Rope tensioner (included)
  • Drywall anchors (2x) (not included)
  • Screws (2x) (shaft must be smaller than 10 mm in diameter) (not included)
  • Paracord (the length depends on the height of your ceiling) (not included)

Print Instructions

  • Material: PLA or PETG
  • Supports: No
  • Orientation: Print everything with its bottom facing the build plate

Assembly (as shown in photos)

  • Step 1
    • Cut your paracord to length (the paracord needs to be 1.5 to 2 times the distance from your ceiling to the point you want your parking assist to hang to)
    • Thread one end of the paracord through the ball
    • Then thread the same end through the stopper
    • Tie an overhand knot on that end of the para cord to stop it from sliding out
  • Step 2
    • Thread the other end of the paracord through one of the holes on either end of the rope tensioner
    • Then thread the rope into the middle hole of the rope tensioner
    • Thread the rope through the ceiling bracket
    • Pass the paracord through the last hole in the rope tensioner
    • Tying overhand knot in the para cord to stop it from sliding out of the rope tensioner
  • Step 3
    • Place the ceiling bracket on the ceiling where you would like your parking assist to hang from
    • Well you hold the ceiling bracket in place, push your screws through the holes in the ceiling bracket to make indents in the drywall
    • Screw your drywall anchors into the ceiling, using the indents that you made in the drywall as a guide
    • Screw the ceiling bracket into the ceiling using the drywall anchors
    • Adjust your parking assist to the correct height

If you enjoy this model, please leave a like and a comment. Please contact me if you have any questions, concerns, or problems.

Tags



Model origin

The author marked this model as their own original creation.

License