2-Piece Fence for Litter Robot III

Fence design for the Litter Robot III by Jason, but split into 2 pieces for easier printing. Requires glue.
1
11
0
98
updated September 22, 2024

Description

PDF

Other required parts can be found in original model

This is the fence design for the Litter Robot III by Jason, but split into 2 pieces for easier printing. This will need to be glued together. 

The overlap area has been extruded down 0.01" on each side for a total of a 0.02" gap on the area to be glued. I printed at 0.28mm resolution, and when supergluing together, this resulted in a flush join. 

Printed on an Ender 3. 

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

This is the fence design for the Litter Robot III by Jason, but split into 2 pieces for easier printing. This will need to be glued together. The overlap area has been extruded down 0.01" on each side for a total of a 0.02" gap on the area to be glued. I printed at 0.28mm resolution, and when supergluing together, this resulted in a flush join. 

License


Highlighted models from creator

View more