Contact Dispenser

WHAT YOU NEED TO PRINT:

1x Contact Holder

2x (One for each side) Contact Holder Peice

Contact Holder Fix is if something breaks.

I wanted easier and more space efficient way to store my contacts, so I made this which can stack up to around 20 contacts for each eye in a dispenser.

I added the sliding shelf, or the file "contact holder piece" because if you just drop the contact down into the dispenser to load or refill it they will bounce and get stuck sideways. If you print one of these pieces for each side, you can lift it up and easily put the contacts into place on each side.

The file "contact holder fix" is because while I was taking supports off, one of the tiny cutouts keeping the contacts in place broke off. I made this to tape/adhesive onto it and I included it just in case this happens to you.

This only works with contact that are around the same size as the ones I have. Mine are around 4.5 by 3. If yours are close to that they should work fine. The tolerances are pretty loose so if yours are a tiny bit bigger that will be fine.

Print Settings

Printer Brand:

Creality

Printer:

No

Supports:

0.2

Infill: