Ender 3 V3 SE Side Mount Camera Arm

The original solution of clamping to the printer did not work well. So this version uses the mounting holes on the side.
6
15
1
152
updated September 24, 2024

Description

PDF

This model is used to secure a camera arm (https://www.printables.com/model/707649-logitech-c925e-mount-ender-3-v3-se) to the side of the Ender 3 V3 SE. The original model (https://www.printables.com/model/643096-ender-3-v3-se-front-mount-for-pi-camera-arm) with double sided tape wasn't secure enough so I made a different solution. I plan on getting longer hardware so I can mount this along with a tool / screen holder using the same holes (https://www.printables.com/model/705882-ender-3-v3-se-tool-holder). 

 

Printed with the flat side down and it was a little bit of a pain to remove the supports from the holes.

 

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

Instead of fitting around the printer base and securing with double sided tape, this version utilizes the 3 mounting holes on the side of the printer. 

License