Flow Scarf Seam Test(Anycubic Slicer/Orca

When Anycubic upgraded the Anycubic Slicer adapted from Orca Slicer I experimented to see if I could minimalize the seam in round objects that can't hide the seam. I found the below settings to work on my Anycubic Kobra 2 Neo.

Brim is needed if the build plate is not clean

Skirt - On(I prefer to use 4 loops)

Seam position - Back

Staggered inner seams - Checked

Seam gap - 40%

Scarf joint seam - Contour and holes(to allow for any holes in model)

Conditional scarf joint - Checked

Scarf joint speed - 90mm/s

Scarf around entire wall - Checked

I have the original default settings with Scarf joint off for the model on the left in the picture. The cylinder on the right is after the above setting was on. the smaller size is due to the spool being almost empty.

I hope this helps, let me know if you get better results with the settings tweaked further,