LED strip case

A case for a LED strip, consisting of a bottom and top parts. The LED strip can be loosely put in the case, or can be fixed to it using double sided tape thanks to to 1 mm extrusion in it. The case can be closed using two 2 mm screws and nuts. Holes have been shaped to accommodate the head of the screws and the nuts, so they don't tip over the case.

The case is 0.7 cm thick, while being 26.4 cm long and 1.8 cm wide, but you can easily change these dimensions using the provided step files, or by duplicating my original Onshape document. 

Some holes have been carved in the top part of the case to allow some cooling air flow, but be sure to test your setup to ensure it is properly wired and do not overheat.