Daft Punk "STARBOY California" Numberplate

This model is designed to be printed with a few filament swaps.
The model should be printed with a layer height of 0.2mm.
You start by printing in red up to layer 4, at 0.8mm.
Then, you swap the filament to white and print up to layer 11, at 2.2mm. After that, you do the final filament swap, changing from white to blue, and let the print finish completely.
The end result will look as if it was printed with a multi-material unit.

Of course, there’s also a version of the model that can be printed using an MMU, where you don't need to manually swap filaments. To print the multi color one on a Prusa MK4 with mmu the model need to be scaled down to 80%, on a Prusa XL you can leave it at 100%

Happy printing!