Sponge holder

Comes in multiple versions; a single with a hex-ish grid or voronoi pattern and a double with voronoi patterns. I found it best to print it turned 90°; some supports will be needed, but they pop out easily. You can then use double sided tape to stick it on under the cupboards.

Tip: When you put down the sponges put them with the coarse side turned upwards! Due to the filament being a bit rough it tends to rub off and get in the tiny cracks. Depending on the color this might not matter, but on a bright color like yellow or white it will end up looking like mold… ^^° Probably you could also lacquer it, but I didn't try that.

Material: PLA at 0.2mm