FPV Quad Rx Antenna Mount (Frame: Dragon HX5)

Quadcopter Rx antenna mount for receivers mounted below the top plate

The antenna guides are tilted back to make the screw holes easily accessible. A compromise of 35° tilt instead of the desirable 45° to the sides had to be made.

Uses 2x M3 screws with slotted holes to accomodate distances between 22-31mm. It is designed for a body width of 42mm and used on a Dragon HX5 frame, but it should work on a variety of 5" frames.

v1.2 longer tubes without the need for heatshrink

v1.1 first published versions, but needed heatshrink around the antenna to not have it flop around while flying

Disclaimer: This is an original design by me from years ago that I decided to now also post on this site.