Dummy 13 V1.0 Minimal Kit card (Male/Female/Hands)

Model of Dummy 13 V1.0 on super light runner. When you have adhesion problem and don't want to waste plastic on runner.
1,166
4144
15
27 k
updated October 24, 2024

Makes

Comments

Scaled to 150%, printed without issue.

Thanks for sharing.

Perfektne. Ako styl abc casopisovych modelov

LOVE this minimal trash, but... REMEMBER to turn on Arachne or Detect thin walls or the spokes may disapear when ya slice.

4.5 stars, that's my only complaint. Easy enough to work around, but...sometimes I forget.

Dobrze przemyślany model trochę szybciej drukuje

Good idea, but I had issues with this model. The spokes of the runners are too narrow and separate easily during print. 0.8mm spokes printed in two passes would be better. Reverted to the original model on runners for armour and finished make.

View one more comment

@Qeepo Nice! Were you able to get the frame runner to fit on the bed?

@Kai_EVO_1595115 I was not... the frame runner kit was too wide, so I only print scaled armour from Vasichkin

Big fun!!! Printed using PETG. 25% on the Armor, 80% on the frames. Requires a bit of filing and sanding to get things to pop into place, but not too much. Printed @ 200% scale. Going to do a 500% print soon.

throwing this a 5 because the original runner was too big to fit on my v0.2, but this one hits the mark. printing now will reply with the results later :)