Pushy - an XR/Funwheel Footpad

Last photo shows Pushy+wing (left), Pubpad and wing (right) to get a better idea of the concave. Mostly just added a little more ramp to the edges.

Sep-08-2025: Realized bad export of the rear pad, uploaded correct file with no hole in it.

Pub + Mushy = Pushy. A remix of Huff Design's 3d printable PubPad, with some influence from the VOW systems Mushy. Includes: resurfaced top for a little more complex concave vs just flat angles, various fillets, a extra couple of fake mounting hole since the gap bothered me, and a few other minor tweaks to add rigidity across the pad.

Also includes a version with a recess for StokedStock v3/v4 sensors, to aid in alignment and protection of the sensor(confirmed to fit a v4, assuming it will fit v3).

Added a wing that continues the concave geometry and blends into the pad's lines a little more than the original wing.