I have an Aqara Button in my bedroom to control the lamps on either side of the bed, and I really wanted it to act as a sudo light switch for the room since the only light switch in the room was for the fan to turn off and on. So, this is a quick model I designed to hold the Aqara Button tight and sturdy against the wall and ti make it look like a normal face plate on the wall.
It is designed to take small command strip velcro strips on the back side. You can also ad short face plate white screws if you wish or screw them into an existing box if there is nothing else in there.
Definitely not a finished model. No supports needed (okay maybe small ones where the command strip goes but mine printed fine without)!
The author marked this model as their own original creation.