Led Cube Lamp - Replacing panels and colored light

MORE PANELS: https://makerworld.com/en/models/649862#profileId-576349

~Hello!~

After the positive reception of the previous decorative lamp model

I wanted to create another one — easier to make and offering more possibilities. There’s no need for an AMS system to print it.

-All you need is any LED light, such as the one sold on the official BambuLab website.

When assembling the model, don’t be afraid to use some force! It’s necessary the first time after printing :)

Hold the wall from the inside and then firmly push the corner of the panel with full force. When removing it, push out each corner of the panel one by one from the inside.

The model is very easy to assemble and allows for changing the panels in seconds, and you can mix them without any issues.

An additional option is the ability to print a colored panel that can be inserted from the inside, which allows you to have colored light on each side of the lamp.

*If you want colored light on the top, you can attach a colored panel with tape or print the model in color for the first few layers, then switch to white.

Note! If you're using colored panels and the base won't close properly or the panel falls out, it means you're installing the panel incorrectly. Rotate it 90 degrees. The shorter side relative to the circle on the panel should go into the base.

I will be releasing interchangeable panels as a new print profile

I’m providing a template that can be easily edited by cutting out your own design. I encourage you to create your own panels and share them!

If you’re unable to fit the panel on a particular side, remove it and start the assembly from the side that wasn’t fitting. This should solve the issue. When removing the panel, push it from the inside to avoid breaking the model.

A great option is to use transparent filaments for printing the base, as they allow even more light to pass through. However, regular filament also works well.

I hope you’ll enjoy the model and that it will decorate your desk!

Thank you so much for every download, comment, rating, and boost! It means a lot to me and brings me great joy :)

Yes, you can sell the model and edit it for your own needs without crediting me as the author :)

In the future, I plan to add more designs, so if you have any ideas, feel free to share them in the comments! :)

HAVE FUN!

CHECK OUT MY OTHER MODELS! :)

1. https://makerworld.com/en/models/542032#profileId-459602
2. https://makerworld.com/en/models/559614#profileId-478816
3. https://makerworld.com/en/models/504769#profileId-420419
4. https://makerworld.com/en/models/586849#profileId-508119