Prusa enclosure stabilizing feet

Feet using the left over foam pads from the prusa enclosure build to stabilize the bottom of the enclosure
3
10
0
100
updated September 18, 2024

Makes

Comments

Have been using this for a while and it has really helped stabilize the printer in the enclosure.

This works. You will need M3 x 12 screws but if the countersink was 0.5mm deeper, then you could use M3 x 10 screws. The rear legs could also have a small setback so that it does not rest on the frame but this does not affect the feet itself.

@HHW_1368847 Ah, yes, i just took some of the leftover screws from the whole prusa enclosure/mmu3-build, without really thinking of the length, sorry.

All comments loaded