Small Fiskars knife cover

A knife cover for the blade of the small Fiskars knife.

It's a bit narrower than the actual blade to have a tight fit.

Printed in PLA:

• 2 shells
• 3 bottom and top layers
• 0,2 mm layer height
• infill doesn't matter
• brim plate adhesion was enough to print in place
• normal supports touching only from the buildplate !NOT EVERYWHERE! - you don't want to remove supports from the inside of the cover :)

POSITION THE MODEL VERTICALLY! Best result if the curved edge is on the build plate - like in the picture (the least amount of supports).

For reference - The coin diameter on the picture is 22,5 mm.