Gridfinity SD Card Holder Easy Grab
Description
PDF"Holds 4 full-size SD cards in a 1x1 Gridfinity square.
Awesomeness:
- Holes are 2CM deep (SD cards are 3CM) so even if you bump it, they won't go flying all over the place
- Holes are offset, creating a 1CM gap for your fat fingers to go either side and pick out a card easily
- Holes are filleted to guide the card in even if you're not really paying attention to what you're doing
- Module has a lip, so you can stack stuff on top of it if it's empty
Why:
Other models I found all required frickin tweezers to get at the card you wanted, and launched the cards all over the room if you even thought about bumping them. This fixes both of those problems!
How 2 print pls halp:
- PLA
- No supports
- Poosh Buttan - Receive SD Holder
- Only works when printed in orange. All other colours will not properly contain the colours of the videos or images on your SD card."
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Remixed from @dswinton
Fixed the tolerances to make the cards not fit not so snugly. Their design was well done, but one of the slots was much tighter than the others. I also found that all slots were just a bit to snug for my liking, meaning that as I tried to remove an SD card, sometimes the bin would come away with the SD card. So I just adjusted those few things.
I'll include @dswinton description, because he had it correct. Please go give him a like or a follow.
