Fishing rod holder for mounting on a vertical railing shaft with a diameter of 25 mm, as often found on sailing boats. The fishing rod can simply be slid in and is hold with slight tilt. This means that the rod can also be used as a trolling rod (if the rod has the necessary strength).
Compared to other holders, this model should be much easier to print, as only two parts are required, which lie on very large surfaces and no complicated fillings are needed.
The attachment and connection of the two parts can certainly be simplified. But the first prototype has completely fulfilled its purpose, at least for a whole week of sailing :-)
The Autodesk Fusion project is attached for further modifications and adjustments.
The model was printed with PLA and 20% infill. To screw the two individual parts together, four M4 screws (30..40 mm long) with nuts are used.
The author marked this model as their own original creation.