Mold for silicon nozzle wiper

This is a mold to cast a silicon nozzle wiper that you can glue to the printing plate protecting it during the nozzle cleanup in the K1 max startup cycle.
Print the mold and use high-temperature silicon sealant to cast the wipe, once cured I glued to the printing plate using the silicon sealant as the adhesive.

To make sure I would be able to remove the wiper with minimal damage to the plate, I made sure it had a layer of Elmer's glue in the plate before I glued the wiper.

I used it for some printing cycles and didn't get any problems from it.

Use at your own risk.