Sidewinder X2 Fan duct/mount

Here is a 4010 fan mount (40mm x 40mm x 10mm) for Artillery Sidewinder X2.

You need :

• 1x 4010 Fan 24V
• 2x 3x20 mm screws with bolts

Step 1 : Glue the two parts that you printed, making sure to do it the right way

Step 2 : Push the two bolts into place using a soldering iron

Step 3 : Remove the blue cover and connect the fan to the 2 pins (CHECK THE VOLTAGE OF YOUR FAN, I USED ONE OF 24V)

Step 4 : Place the part using the two screws from your printer to the blue aluminum plate

Step 5 : Screw in the fan and use the two small printed tubes if your screws are too big (check the direction of the fan so it blows in the right direction)

I recommend using a nozzle heat resistant filament such as PETG