Lack Drawer with Inset Label

A remix of MHavoc's remix of Jerrari's drawers for the Ikea Lack table.

This remix adds a small inset label region to the single-width drawer. The inset is 60mm W x 19mm H. The included label blank is that size, but may need to be printed slightly scaled down to press-fit.

I printed these at 0.2mm height, with auto-generated supports. The supports are likely not necessary if you're going to use a sticker label, but I wanted to achieve a really consistent overhang for a press-fit printable label. You can see the supports still attached to the middle drawer in the photos.