Sorting Tray (Hidden Magnets!)

This is a great functional tray that is great for use with small nuts and bolts so you don't lose them!
In the contest Sorting Trays
19
17
1
131
updated September 15, 2024

Description

PDF

This is great functional model that is a great design while implementing every day 3D printing principals! This particular model is very functional to the point that you can turn the model up This model has hidden magnets near the bottom of the base of the print, refer below to see when to pause the print. 

Also feel free to reach out for questions, makes, improvements or anything else! I always love to hear from you guys! 

I have uploaded two version of the model, one would require four total magnets, the other would require eight this would help keep more inside the sorting tray.

*IMPORTANT* Here are the points at which you should pause the print. If you print the model with four magnets pause the print at, ‘4.60.’ If you print the one with 8 magnets pause the print at , ‘4.60.’ I used the settings 0.20 Quality so that would affect which layer you pause the print at.

 

Print Settings:

Infill: 15%- 30%

Infill Type: Gyroid

Supports: NO

Filament: PLA, PETG, or ABS/ASA.

Use this link on Amazon for the magnets: Amazon Link 15x2 Millimeter Thin Magnets

Or go to the Maker-Supply on Makerworld for the magnets (If you get from Maker-Supply get the set of CA018 magnets) : Maker Supply 

*Also sizes in the photo are a little smaller because I am low of filament, so if you can please visit my Patreon and buy me a roll to support me further on! Thanks!

 

Also make sure to check out my new patreon page! If you join for free you can receive exclusive models only on my patreon! Also have access to more updates, polls, and many other things!  My Master Printer Patreon

 

 

Also if you want me to make any alterations or improvements to the model make sure to send me a message! 😊

 

Tags



Model origin

The author marked this model as their own original creation.

License