HEPA filter gasket for the Erabros LS1 Robotic vacuum cleaner

Earlier today, I almost threw away the gasket for the HEPA filter used on my Erabros LS1 robotic vacuum cleaner and mop. Luckily, I was able to fish the gasket and filter out of the trash before they were gone for good. I checked Amazon (and Printables!) for a replacement, and they don't appear to be available at all. I love this little robotic vacuum companion, so I decided to make a TPU version of the gasket.

I printed the gasket in Sliceworx Red TPU at .2 mm layer height, 5 perimeters, 100% infill. I chose 5 perimeters in the hopes that it would provide a better seal. No supports are needed. I recommend a bright TPU color, since it will be a lot more obvious when it's installed. The original gasket was the same grey color as the dust and cat hair the vacuum was gobbling up, so it was naturally camouflaged when I emptied the dust bin into the trash.